View Full Version : Moulding| how to?

03-06-2006, 05:19 AM
I\'ve heard a few people make refrence to this, what exactly is it? it involves greenstuff but thats the end of my knowledge.


03-06-2006, 05:32 AM
Do you mean sculpting (taking a material and shape it) or using moulds to mass produce something?


03-06-2006, 05:34 AM
I\'m thinking of somet i saw in an old WD and wondered if people ever use greenstuff to get a shape of badge/pad or somet and wating till its dry then makin a mold with greenstuff...


03-06-2006, 02:09 PM
If you mean moulding GW bits, I\'m not sure what the policy on that is but I think it\'s getting into the grey area. I know other forums have had trouble with this before so we should look into it.

04-06-2006, 06:45 AM
The WD article referred to making a mould of purity seals. It involved wrapping a bit of GS around a pencil in a blob and then rolling it over a purity seal, imprinting the shape into the blob.

It was left to set and then they simply pressed GS into the set mold and cut out the molded shape.

If WD recommended it, then it must be ok.


04-06-2006, 06:28 PM
I know this isn\'t exactly what you guys are on about but there\'s a decent purity seal \"how to\" on the GW site, also other green stuff artciles.


A lot of you might have seen it already, but thought I\'d share it as I\'ve found it useful.

05-06-2006, 02:19 AM
I think i know what you mean Torn told me about it in this thread moulds (http://www.astronomican.com/index.php?option=com_joomlaboard&Itemid=&func=view &catid=21&id=4000#4000)

Post edited by: mark, at: 2006/06/05 02:21