PDA

View Full Version : how do i get my green stuff to dry?



mclovin95
10-01-2009, 04:47 PM
okay so i had finished building and priming vulkan and even used him in a match but the supid cloak of green stuff is still moving and sorta of mushy how and when will it dry?:confused:

Captain Castus
10-01-2009, 04:50 PM
It should cure within 24 hours...

CC

Consadine
10-01-2009, 04:51 PM
Do you have a picture or two so we can see how thick the cape is?

Carrelio
10-01-2009, 07:27 PM
Depending on how much blue you mixed in the drying time will be different. But don't worry too much, withcommander Scraps, he didn't quite dry until about a week after he was finished. Just let him be for a bit and everything should work out fine.

mclovin95
10-01-2009, 09:58 PM
uhoh..... i didnt use any blue.......:(

Consadine
10-01-2009, 10:01 PM
O.o How did it turn green then?

mclovin95
10-01-2009, 10:07 PM
theres a green side and a blue side and i only used green.... am i screwed..... if is i hope its not like a light bulb....:)

Consadine
10-01-2009, 10:13 PM
I was sure GS came in a strip of blue and yellow... they mix to be green... regardless, it's a two-part epoxy (I'm sure that's right) and you'll need to mix the two to start the chemical reaction that hardens hours later.

mclovin95
10-01-2009, 10:27 PM
woah thats yellow.........:o

mclovin95
10-01-2009, 10:41 PM
okay so should i rip off the cape and tasset and make a new pair or just take off a thin sheet of the blew stuff and just stick it on.

Arkaedin
11-01-2009, 01:42 AM
okay so should i rip off the cape and tasset and make a new pair or just take off a thin sheet of the blew stuff and just stick it on.

You need to thoroughly mix the yellow and blue so you have to start ALL over ;)

mclovin95
11-01-2009, 01:54 AM
okay cause i did and i just smushed the the blue and yellow togeather and stuck it on, i pray to the empreor for the best..... if it dosnt work out i think ill pursue my hell jumpers.....

Captain Castus
11-01-2009, 07:34 AM
A very well mixed blob of 50:50 yellow and blue is a good starting point! ;)

CC

Starky
11-01-2009, 09:13 AM
Make sure you have a consistent colour through out the putty to ensure the gs cures properly.

Starky